Doorking 1820 Manuel d'utilisateur télécharger pdf (Page 43)

3.7 Virtual Doorman

The virtual doorman is an independent system that provides communication from the lobby area to a

company that provides doorman services. The virtual doorman service is completely separate from

the 1820 system and does not utilize the 1820 lobby panel or any communication circuits provided by

the 1820 system.

When virtual doorman service is active and a call is initiated from the 1820 lobby panel, the 1820 will

provide a dry relay contact to the virtual doorman system to activate the virtual doorman system. At

the same time, the 1820 will disconnect the lobby panel and hang up. The virtual doorman

equipment will provide all communication and door access for visitors.

3.7.1 Virtual Doorman On / Off – System Wide

This programming sequence is used by the doorman or system administrator to turn the virtual

doorman function On or Off and sets the 1885 on board relay to function as a virtual doorman relay or

a door strike relay.

Factory Default = 0 (Off)

1. Take the doorman telephone off hook.

2. Press *52 and enter the four-digit MASTER CODE _ _ _ _ (beep).

3. Enter 0 to turn virtual doorman Off, or enter 1 to turn virtual doorman On, then press *

(beep).

4. Hang up the doorman telephone to end the programming session.

3.7.2 Set Virtual Doorman Relay Strike Time

This programming sequence is used by the doorman or system administrator to set the strike time for

the virtual doorman activation relay. Strike time can be set from 1 to 99 seconds.

Factory Default = 01

1. Take the doorman telephone off hook.

2. Press *53 and enter the four-digit MASTER CODE _ _ _ _ (beep).

3. Enter a two-digit strike time (01-99) _ _ then press * (beep).

4. Hang up the doorman telephone to end the programming session.

3.7.3 Virtual Doorman On / Off per Resident

This programming sequence is used by the doorman or system administrator to turn virtual doorman

On or Off for each resident or for all residents. Entering 9 9 9 9 in this step will turn this feature on or

off for ALL residents. Resident’s can turn this on or off from the apartment using resident commands.

Note: If programmable directory codes are used, enter the directory code number instead of

the relay number in step 3.

Factory Default = 0 (Off)

1. Take the doorman telephone off hook.

2. Press *43 and enter the four-digit MASTER CODE _ _ _ _ (beep).

3. Enter the four-digit relay number of the resident that virtual doorman is being

administered for _ _ _ _ then press * (beep).

4. Enter 0 to turn virtual doorman Off, or enter 1 to turn virtual doorman On then press *

(beep).

5. Repeat steps 3 and 4 to administer virtual doorman for other residents.

6. Hang up the doorman telephone to end the programming session.

1820-065-B-2-06 Page 43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 62 63

Commentaires sur ces manuels

Pas de commentaire

Doorking 1820 Manuel d'utilisateur Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Téléphones Doorking 1820