Doorking PC Compatible Multi-Door Access Controller 1838 Manuel d'utilisateur télécharger pdf (Page 32)

3.4.5 Delete Phone Number

This programming sequence is used to delete the phone number under a known directory code.

1. Press *

0 1 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in

3.5.1) then press *

(beep).

3. Press #

# # # # # # then press * (beep).

4. Press 0

# TOGETHER to end this programming step (beeeeeep).

3.4.6 Delete Area Code

This program sequence deletes the area code programmed into the system.

1. Press *

2 4 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter 1

then press * (beep).

3. Enter #

# # # then press * (beep).

4. Press 0

# TOGETHER to end this programming step (beeeeeep).

3.4.7 PBX Line Access Code Programming

If the 1838 / Remote Call Station system is connected to a PBX telephone system rather than a

dedicated C.O. line, you may need to set the unit to dial a line access code prior to dialing the a

phone number. Typically, the line access code is “9”, but check with the PBX system administrator to

be sure.

1. Press *

0 9 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the line access code number _ then press *

(beep).

3. Press 0

# TOGETHER to end this programming step (beeeeeep).

NOTE: To change a line access number, enter the correct number in step 2. To

delete a line access number, enter # in step 2.

Page 32 1838-065-L-3-10

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 48 49

Pas de commentaire

Doorking PC Compatible Multi-Door Access Controller 1838 Manuel d'utilisateur Page 32