Doorking PC Compatible Multi-Door Access Controller 1838 Manuel d'utilisateur télécharger pdf (Page 28)

3.3.3 Tone Open Numbers

These steps will program the tone open numbers for relays 1 and 2. You will need to enter a four-

digit number (see chart below) to set the relay functions. If a function is not desired, enter # in place

of a number. For example, if you want the relay to have a momentary activation function only, and

you want the relay to activate when the number 9 is pressed on a touch-tone phone after calling the

system, enter 9 # # # in step 4. Do not duplicate tone open numbers, i.e., don’t set relay 1 and 2

tone-open numbers all to 9. If Tracker expansion boards are connected to the system, there is no

need to set a momentary open tone open number for the tracker control relay(s). However, you may

want to set HOLD and DEACTIVATE tone numbers, which will allow management to have a function

to automatically unlock all doors/gates controlled by a Tracker board (refer to 4.2.2).

Factory setting is: Relay 1 = 9876, Relay 2 = 5432.

1. Press *

0 5 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Press 1

* to set relay 1 or 2 * to set relay 2 tone numbers.

3. Enter the four-digit tone open number code _ _ _ _ then press *

(beep).

4. Repeat steps 2 and 3 to set the other relay tone open numbers.

5. Press 0

# TOGETHER to end this programming step (beeeeeep).

NUMBER FUNCTION

Digit Momentary activation. Relay will activate for the programmed strike time (3.3.1).

Digit Relay hold. Relay will activate and remain activated until commanded to release.

Digit Relay release. Deactivates the relay hold command.

Digit Relay hold 1-hour. Relay will activate for 1-hour and then will automatically deactivate itself.

3.3.4 Input Switch

This programming sequence sets what relay(s) will activate when the input (postal) switch input is

activated on the access control system. The system can be programmed so that only one relay will

activate, or any combination of relays will activate. To cause a relay to activate, enter a 1 in it's

respective character slot, or enter a zero to not activate the relay. Any combination of 1's or 0's is

permissible. For example, entering 010 in step 3 will cause only relay 1 to activate. Entering 011 will

cause both relay 1 and relay 2 to activate.

Factory setting = 010.

NOTE: Although you are setting the input switch activation for two relays only, you must

enter a three-digit code in step 2. Always use 0 as the first digit.

1. Press *

5 0 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the three-digit (1's or 0's only) postal relay code _ _ _ then press *

(beep).

3. Press 0

# TOGETHER to end this programming step (beeeeeep).

Page 28 1838-065-L-3-10

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 48 49

Pas de commentaire

Doorking PC Compatible Multi-Door Access Controller 1838 Manuel d'utilisateur Page 28