DoorKing 1812 Manuel du propriétaire télécharger pdf (Page 12)

Page 12 1812-065-M-3-07

1.2 FLUSH MOUNT UNITS

Flush mount units are designed to be mounted directly into a wall or column. Be sure the unit is

mounted securely and is not subject to vibration from closing doors or gates.

If used to control a vehicular gate with an automatic gate operator, the

telephone entry system must be mounted a minimum of ten (10) feet away

from the gate and gate operator, or in such a way that a person cannot

operate the entry system and/or touch the gate or gate operator at the same

time.

The rough-in box should be installed prior to installing the flush mount unit. Be sure that the rough-in

box is securely mounted and is not subject to continuous vibration from closing doors or gates.

1. Be sure that the rough-in box is securely mounted into the wall or pilaster. Route any pre-

wiring into the rough-in box at this time.

2. Open the cabinet of the 1812 and carefully disconnect the front panel terminal connector

and the keypad connector. The front panel terminal connector is located in the lower right

hand corner. Do not disconnect the wires from this connector. The entire connector will

come off the board by gently pulling it straight out.

3. Remove four (4) 6-32 a 1/2 round head screws from each corner of the control board.

4. Remove the control board from the housing. CAUTION: The control board contains static

sensitive components. Discharge any static electricity from your hands by touching a

proper ground device before removing the control board.

5. Mount the 1812 housing assembly into the rough-in box using four (4) 6-32 x 1/2 screws

supplied. Mounting holes are located in each corner of the back box and will align with

PEM nuts in the rough-in box.

6. Make conduit connections and route wiring into the housing assembly at this time. DO

NOT APPLY POWER.

7. Clean out the back box. Be sure that all dirt, metal or wood debris is removed from the

back box.

8. Remove the main terminal wiring connector from the control board by gently pulling it

straight up. This will make wiring to the main terminal easier.

9. Install the control board into the back box. Secure the control board with the four (4) 6-32

x 1/2 screws removed in step 2. CAUTION: The control board contains static sensitive

components. Discharge any static electricity from your hands by touching a proper

ground device before installing the control board.1

10. Plug the front panel connector onto the control board pins in the lower right hand corner.

The red wire goes to the left.1

11. Plug the keypad connector onto the circuit board plug. The cable points down.1

12. After pre-wiring the main terminal control board connector (see wiring instructions),

carefully re-install it onto the control board main terminal pins.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 46 47

Pas de commentaire

DoorKing 1812 Manuel du propriétaire Page 12