DoorKing 1812 Manuel du propriétaire télécharger pdf (Page 21)

SECTION 2 – PROGRAMMING

The DoorKing 1812 Telephone Intercom System can be programmed by three different programming

methods.

•

KEYPAD

: The keypad on the front of the entry system can be used to program all features in

the 1812 unit. The MASTER CODE can only be programmed from the keypad.

•

COMPUTER

: Using the DoorKing Auto-Programming Software for Windows, almost all of

the programmable features provided in the 1812 unit can be set using a PC.

•

TELEPHONE

: Using a touch-tone telephone, many of the programmable features can be

programmed from the house or remotely from an off-site location.

IMPORTANT

We strongly suggest that you read these programming instructions in their

entirety before beginning any programming of this telephone entry system

2.1.1 Programming from the Keypad

Follow the programming instructions as described in each section of this manual. The system will

prompt you with short tones (beep) when programming steps have been followed correctly, and with

a long tone (beeeeeep) when the programming step is ended.

This symbol

in the programming steps indicates numbers that you will need to enter, one number

per symbol.

2.1.2 Programming with a PC

Prior to programming the system with a personal computer and the DoorKing Auto-Programming

Software for Windows, there is certain information that you must know and must program into the

1812 before the computer can communicate with it. See page 22 to set-up the 1812 for PC

programming. Programming the unit with a PC may be accomplished either on-site (from the

residence home) or remotely from an off-site location.

2.1.3 Programming with a Touch-Tone Telephone

Follow these steps when programming the 1812 from the resident’s touch-tone telephone. NOTE:

The system attention number is factory set to 7. This can be changed to any number, see 2.2.2.

1. Press and then the system attention number (beep).

2. Follow the programming instructions as described in each section of this manual. The

system will prompt you with short (beep) tones when programming steps have been

followed correctly.

3. When complete, hang up.

Follow these steps when programming the 1812 from an off-site touch-tone telephone. NOTE: The

1812 must be programmed to answer incoming calls.

1. Call the resident telephone number. The 1812 will answer with a short beep after the

programmed number of rings.

2. Follow the programming instructions as described in each section of this manual. The

system will prompt you with short (beep) tones when programming steps have been

followed correctly.

3. When complete, hang up.

2.1 PROGRAMMING INFORMATION

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 44 45

Commentaires sur ces manuels

Pas de commentaire

DoorKing 1812 Manuel du propriétaire Page 21

Commentaires sur ces manuels