Doorking 1820 Telephone Intercom Manuel d'utilisateur télécharger pdf (Page 32)

3.1.7 Number of Rings / Ring Type

This programming sequence sets up the 1820 system for: 1) the number of rings allowed before the

system automatically hangs up if the call is not answered, 2) a single or double ring (when set for

double ring, the first ring will be a single ring). A two digit number will be entered to set up these

operating parameters, with each number of the code corresponding to the respective functions listed.

Factory Default = 31

1. Take the doorman telephone off hook.

2. Press *04 and enter the four-digit

MASTER CODE _ _ _ _ (beep).

Code

Digit

Number Description

Enter the two-digit ring/ring type code _ _

then press * (beep).

4. Hang up the doorman telephone to end

the programming session.

3.1.8 Tone Open Number Programming

The tone open number is the number that is pressed on the resident’s telephone to activate the relay

on the 1885 control board. The resident can only activate the relay momentarily, but other relay

functions are available from the doorman/concierge phone and by remote relay activation. The four

relay functions are: 1) momentary activation, 2) continuous activation (relay latch), 3) deactivation

(unlatch), 4) activate for one hour, then automatically deactivate. If a function is not going to be used,

enter a # sign in place of the respective digit. Do not use the number "3" as a tone open number

since this number is reserved to activate the call waiting feature. Do not duplicate tone open

numbers.

NOTE: When used with a DoorKing Lobby Panel, the 1820 and lobby panel Tone Open

Number programming must match. Refer to the lobby panel programming instructions to

program the lobby panel Tone Open Number programming.

Factory Default = 9 # # #

1. Take the doorman telephone off hook.

2. Press *05 and enter the four-digit

MASTER CODE _ _ _ _ (beep).

3. Enter the four-digit tone code _ _ _ _ then

press * (beep).

4. Hang up the doorman telephone to end

the programming session.

3.1.9 Relay Strike Time

The relay strike time is the amount of time that the relay on the 1885 control board will be energized

when activated by a tone open number, entry code number, or key switch (postal lock) input. Typical

strike time is 5 seconds for an electric strike or magnetic lock release.

Factory Default = 01

1. Take the doorman telephone off hook.

2. Press *03 and enter the four-digit MASTER CODE _ _ _ _ (beep).

3. Enter the two-digit strike time code (00 – 99) _ _ then press * (beep). Note: 00 = ¼ sec.

4. Hang up the doorman telephone to end the programming session.

2 - 9

The number of rings before the

1820 automatically hangs up.

0 or 1

Enter 0 for a standard single ring,

or enter 1 for a double ring.

Code

Digit

Number Description

0, 1, 2,

4-9

Activate the relay for the

programmed strike time.

Acti

vates the relay continuously

(relay latch).

Deacti

vates the relay (relay

unlatch).

Acti

vates relay for 1-hour, then

automatically deactivates.

Page 32 1820-065-E-12-11

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 62 63

Commentaires sur ces manuels

Pas de commentaire

Doorking 1820 Telephone Intercom Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Téléphones Doorking 1820 Telephone Intercom